PMCL-AC160TSA

Also known as OTESPA with Au reflex coating; silicon probe with visible apex tip for tapping mode

OUTSTANDING FEATURES

1. Suitable for use with a wide range of sample surfaces
2. Doped silicon cantilever
3. Ideally point terminated probe
4. Acclaimed ‘TipView’ structure
5. Reflex side aluminum coating
6. Ease in chip handling
7. Packaging: Pre-separated chips

MORE ABOUT PMCL-AC160TSA SERIES

1. Suitable for use with a wide range of sample surfaces
   The mid-range mechanical properties [resonance frequency: 300 kHz, spring constant: 26 N/m] of PMCL-AC160TSA allow for precise and gentle sample imaging. 
2. Doped silicon cantilever
   The cantilever is made from silicon with a low surface resistance of 0.1 - 0.4 Ω・cm, 1/20 resistance of our conventional cantilevers.
3. Ideally point terminated probe
   The apex of the tetrahedral probe is ideally point terminated. The tetrahedral probe shows good symmetry viewed from the front.
4. Acclaimed ‘TipView’ structure
   The probe can be easily positioned at the exact point of your interest due to ‘TipView’ structure.
   The probe is located at the exact end of the cantilever so that the probe apex is not obscured during optical observations.
   
5. Reflex side goldcoating
   Thin gold (Au) film with the thickness of 50 nm is coated on the cantilever for reflecting light from the deflection sensor in the AFM equipment. High reflex for high S/N sensing can be expected.
6. Ease in chip handling
   The ideally vertical side-walls of the chip make tweezing easy and eliminate problems with chipping and debris.
7. Packaging: Pre-separated chips